Question: In the network below, VLANs 10, 20 and 55 (Native) have been created on the switch SW1. The router R1 is used to provide

  

In the network below, VLANs 10, 20 and 55 (Native) have been created on the switch SW1. The router R1 is used to provide Inter-VLAN routing functionality using Router-on-a-Stick method. Write the commands required to configure the following ports on SW1 and R1 so that, computers from different VLANs (PC1 & PC2) can communicate with each other: 1. SW1 Fa0/10 2. SW1 Fa0/20 3. SW1- Gi0/1 4. R1-Gi0/0 Assume that R1 interface Gi 0/0 has executed the 'no shutdown' command. Also, assume that the router sub-interface numbers match with the vlan ID and the native VLAN is VLAN55. Fa 0/10 Router-on-a-Stick Inter-VLAN Routing R1 VLAN 10 PC 1 10.10.10.0/24 Gi 0/0 Gi 0/1 SWI Fa 0/20 VLAN 20 PC 2 10.10.20.0/24

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock

To enable communication between computers in different VLANs using RouteronaStick InterVLAN routing ... View full answer

blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Programming Questions!