Is there a solution to book Managerial Accounting For Managers chapter 4 case 27?

CASE 4-27 critical Thinking; Interpretation of Manufacturing overhead Rates ILO4-1, Lo4-2) The Sharpton Fabricators Corporation manufactures a variety of parts for the automotive industry. company uses a job order costing system with a de predetermined overhead rate based on direct labor-hours. On December 10, 2015, the company's controller made a preliminary estimate of the predetermined overhead 2016. The new rate was based on the estimated total manu rate for facturing overhead cost estimated 52,000 total direct labor-hours for 2016. of $2,475,000 and the $2,475,000 Predetermined overhead rate 52,000 hours This new predetermined overhead rate was communicated to top managers in a meeting on Decem- ber 11. The rate did not cause any comment because it was within a few pennies of the overhead rate that had been used during 2015. One of the subjects discussed at the meeting was a proposal by the production manager to purchase an automated milling machine built by Central Robotics. The president of Sharpton Fabricators, Kevin Reynolds, agreed to meet with the regional sales representative from Central Robotics to discuss the nronosal CASE 4-27 critical Thinking; Interpretation of Manufacturing overhead Rates ILO4-1, Lo4-2) The Sharpton Fabricators Corporation manufactures a variety of parts for the automotive industry. company uses a job order costing system with a de predetermined overhead rate based on direct labor-hours. On December 10, 2015, the company's controller made a preliminary estimate of the predetermined overhead 2016. The new rate was based on the estimated total manu rate for facturing overhead cost estimated 52,000 total direct labor-hours for 2016. of $2,475,000 and the $2,475,000 Predetermined overhead rate 52,000 hours This new predetermined overhead rate was communicated to top managers in a meeting on Decem- ber 11. The rate did not cause any comment because it was within a few pennies of the overhead rate that had been used during 2015. One of the subjects discussed at the meeting was a proposal by the production manager to purchase an automated milling machine built by Central Robotics. The president of Sharpton Fabricators, Kevin Reynolds, agreed to meet with the regional sales representative from Central Robotics to discuss the nronosal