Question: it's a process control an Instrumentation based problem please solve it A PID temperature controller is at steady state with output pressure at 9psig. The

it's a process control an Instrumentation based problem please solve it

A PID temperature controller is at steady state with output pressure at 9psig. The set point and process temperature are initially the same. At t=0, set point is increased at the rate of 0.5C/min. If the controller knob settings are 2psig/C, integral time 1.25min, derivative time 0.4min, plot the profile of output pressure with time. 5

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Chemical Engineering Questions!

it's a process control an Instrumentation based problem please solve it 4. A pneumatic PI controller has an output pressure of 10psig when the set point and process temperature coincide. The set...

it's a process control an Instrumentation based problem please solve it 5. Construct the block diagram of a feed back control system comprising an integrating level process, a P controller with gain...

I can't understand your solution. please more detail step-by-step solution 9.4. A PID temperature controller is at steady state with an output pressure of 9psig. The set point and process temperature...

9.4. A PID temperature controller is at steady state with an output pressure of 9psig. The set point and process temperature are initially the same. At time t=0, the set point is increased at the...

2. An electronic parallel form of PID temperature controller is at steady state with an output of 12 mA. The set point equals the nominal process temperature initially. At t=0, the set point is...

I will gladly give a thumbs up for the good effort! A PID temperature controller is at steady state with an output pressure of 9 psia. The set point and process temperature is initially the same. At...

EXPERIMENT G1: Dynamic Response Modelling a Temperature Controller Tuning in a Jacketed Flow Reactor Objective This experimeot involves a jacketed, mixed flow reactor in which an exochermic (heat...

EXPERIMENT G1: Dynamic Response Modelling & Temperature Controller Tuning in a Jacketed Flow Reactor Objective This experiment involves a jacketed, mixed flow reactor in which an exothermic (heat...

Task 1: Multiple production lines exist in a water bottling factory. The most automated part is the filling line, where plastic bottles are placed on a conveyor belt and driven towards a filling...

OBJECTIVE **INVESTIGATION OF THE PER RECIPROCATING COMPRESSOR AT VARIO P1 & T1 = COMPRESSOR DISCHARGE/CONDENSER P2 & T2 = CONDENSER OUTLET/EXPANSION VALVE P3 & T3 = EXPANSION VALVE OUTLET/EVAPORATOR...

Boat Hull Manufacturing produces boat parts at the manufacturing facility in Virginia. The managerial accountant reported that Boat Hull Manufacturing manufactures parts to repair the container ships...

Using the information in E6-7, prepare journal entries to record the transactions, assuming Axe uses a perpetual inventory system. Info E6-7 Jan. 6 Purchased goods for $ 1,200 from Green with terms...

The major source of short - term debt for most providers is a line of credit bonds commercial banks shareholders

3- As we have learned previously in the first chapter, profit maximation is one of the financial goals. Take a look at the table below, and give opinion on which is the better investment, out of the...

Individually design a job specifi cation for a university lecturer in marketing, then compare results in groups of fi ve. Produce a fi nal version taking the best parts of each of your efforts.

Set out some of the opportunities presented to Sarah in the Meteor Telecoms case study. How would she best take advantage of them?

It is often said that competencies for a manufacturing environment are different to those for a service environment. Draw up a list of fi ve differing competencies for each sector and three...