Lab 2 Instructions -Linear Kinematics Materials Lab bench (table, desk) iOLab unit Computer with iOLab software installed iOLab dongle Procedure 1. Make sure your lab bench (table, desk) is a flat, horizontal surface which would allow the iOLab unit to roll on its wheels over a small distance of 0.30 m -0.40 m. Place the iOLab unit with its wheels on your lab bench. 2. Place the palms of your hands perpendicular to the bench and so that the iOLab unit is between your palms and practice pushing the iOLab unit back and forth, as shown in the video below: https://www.youtube.com/watch?v=QzWbwC7MkuY&feature=youtu.be3 Open the iOLab software and insert the dongle in a USB port in your computer. Turn on the iOLab unit. 4. From the list of sensors shown on the software display on the screen of your computer select "Wheel".5. Bring the iOLab unit to rest, click the Record button, , and push the unit between your hands as you practiced at the point 2 of the procedure. Stop recording after several pushes. 6. Turn off the iOLab unit. Go to Analysis section and address its part I prompts and questions. Analysis 1. Using the magnifying glass select a portion of the velocity graph to enlarge. Make sure to include four full plateaus. A plateau is a region for which the acceleration is constant and the slope of the velocity vs. time graph is also constant. Take a screen shot with the full display of the iOLab software. This will be the Figure LR2.1 in your lab report. Your screenshot should be similar (only with more plateaus) to the image at timestamp 1:12 of the video below: https://www