Lab no. 3: High Current Output Duration: 1 weeks, requires preparation of the results report at the end. 3- High current output +5-24v o 1N4001 M Pin IRF510 Sometimes it is necessary to control more than 40ma from the Arduino. In this case a MOSFET or transistor could be used to switch higher current loads. The following example quickly turns on and off the MOSFET 5 times every second. Note: The schematic shows a motor and protection diode but other non- inductive loads could be used without the diode. int outPin = 5; // output pin for the MOSFET void setup() pinMode(outPin, OUTPUT); // sets pins as output } void loop() for (int 1=0; i