Lesson 8: Event-Based Dynamic Simulation 8-11 Exercises: 1. Use the same two parts as Exercise 5-1 to create an assembly like that of Figure E8-1. Create an event-based motion study to move the block for 300 mm along the X-direction, then turn the block to the left and move along the negative Z-direction for another 300 mm. Thereafter, turn the block to the right and move along the positive X-direction for another 100 mm. Figure E8-1 Motion Simulation and Mechanism Design Using SOLIDWORKS Motion 2019 135 SCX SAE Kuang-Hua Chang, Ph.D. School of Aerospace and Mechanical Engineering The University of Oklahoma Norman, OK SDC Publications