Loops - Drawing a tree In this programming assignment, you'll draw a tree based on user specifications. The starter program draws a tree, using a triangle with three levels as the leaves and a rectangle with four levels as the trunk 1. Modify the above program to ask the user to specify a number of tree trunk levels (Enter trunk height 0, then use a loop to draw that many levels Testing suggestion: If the user specifies 4 tree trunk levels, than the original tree should be drawn. 2 Modify the program again to ask the user to specify a number of tree trunk "s per level (Enter trunk width: ). then use a loop to draw that many "s per level. You'll need to use a nested loop in which the inner loop draws the "s, and the outer loop terates a number of times equal to the number of tree trunk levels. 3. Modify the program to ask the user to specify a number of tree leaves levels (Enter leaves width: ). then use a nested loop to draw that many levels. You'll need two inner loops for drawing the leaves: one for outputting spaces and one for outputting "s. The outer loop iterates a number of times equal to the number of tree leaves levels Note: Your program only needs to support odd-numbered widths, like the below examples. Here is an example program execution (user input is highlighted here for clarity) Enter trunk height: 7 Enter trunk width 3 Enter leaves width: 5 Here is an example program execution (user input is highlighted here for clarity) Enter trunk height9 Enter trunk width: 5 Enter leaves width: 11 Here is an example program execution (user input is highlighted here for clarity) Enter trunk height 3 Enter trunk width 1 Enter leaves width: 9 earch Ei a