material

solve it now please and make sure that the answer is here

A rod that possesses a circular cross-section with a diameter of 5 9 mm is to be extruded to an inferior final diameter. If the rod is made out of brass for which the yield strength is anticipated to succumb to a value of at least 350 MPa while the ductility surpasses 15% EL in the wake of cold-working, consider the procedure that simultaneously paves the way for a final diameter of 45 mm What would be the corresponding Brinell Hardness value for the final stage of strain hardening adopted? Note: consult with the charts provided in Question 2 [Part 1]. 01. None of the above # 220 HB O M. 126 HB OIV 200 HB QUESTION 18 Arod that possesses a circular cross-section with a diameter of 5.9 mm is to be extruded to an inferior final diameter of the rod is made out of brass for which the yield strength is anticipated to succumb to a value of at least 350 MPa, while the ductility surpasses 15% EL in the wake of cold-working, consider the procedure that simultaneously paves the way for a final diameter of 45 mm With regards to the equivalent Brineli hardness to the extent of work hardening achieved in the final stage One option for the indenter tool matenal would be 11/16 inch Another option for the indenter tool material would be 11.10 mm The standard indenter tool geometry is Ball The standard indenter tool diameter is 1 Hardened Steel V Diamond VI. Tungsten Carbide VII. 18 inch VII Conical