Question: Microcontroller 8051 serial port progrmamming Write a program to transmit serially the message SWITCH ON or SWITCH OFF depending on the status of the simple

Microcontroller 8051 serial port progrmamming

Write a program to transmit serially the message "SWITCH ON" or "SWITCH OFF" depending on the status of the simple switch connected to pin P1.2.Use 2400 baud rate. 1 stop bit, 8 data bits format and assume XTAL frequency as 11.0592 MHz

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Databases Questions!

The Needy Checklist You will need the following equipment for this lab session: Digital Power Supply Breadboard Jumper wires Computer with assembler/IDE 8051 breakout board 8051 programmer You should...

8051 microcontroller and embedded system Write a program to check a switch connected to PI.1. If the switch is on (the value is 1), create a rectangular wave of 10KHz of 66% (2/3) duty cycle on pin...

Temperature Monitor In this assignment you will use the DigitalIn, AnalogIn, and BusOut interfaces on the mbed microcontroller board to implement a simple indoor/outdoor temperature monitor. The...

I have listed my problem statement below. I need help getting started with the code to produce the desired results. Please help me do so. Thank you! Assignment #3 Temperature Monitor In this...

LAB7 Using the 8051 Serial Port and Interrupts Overview The purpose of this lab is to control and program the serial port of the micro-controller in a given sequence. Two switches SW1 and SW2 are...

cricket ? 5:19 PM a mail-attachment.googleusercontent.c C CS 343 LAB7 - Using the 8051 Serial Port and Interrupts Overview The purpose of this lab is to control and program the serial port of the...

Question 4 a) What is meant by an interrupt in a microcontroller and what are the possible sources of an interrupt in the 8051? [5 Marks] b) What is the Interrupt Vector Table and what issue might...

In this assignment, the aim is to question whether there is a frequency of 290Hz in a composite signal containing multiple sine components. 290Hz exists in a certain period of time and then...

The Universal Synchronous Asynchronous Receiver and Transmitter (USART) port in the ATmega16 microcontroller is used to send a character (11010101). Create a C code that will send and configure the...

Write a program that continually transmits characters from a transmit buffer ( internal RAM 3 0 H to 4 FH ) . If incoming characters are detected on the serial port, store them in the receive buffer...

A homogeneous cubic block of side L and weight 200 N resting on a horizontal floor is acted upon by a force of 100 N at an angle of 60 to the horizontal as shown in the figure. If the coefficient of...

Identify elements of satire in the lion and the Jewel and comment on its relevant to the society.

Benchmark error: Multiple Choice refers to the use of an incorrect market proxy in tests of the CAPM, only. refers to the use of an incorrect market proxy in tests of the CAPM and can result in...

Seved Help 14 Wisconsin Snowmobile Corp. is considering a switch to level production Cost efficiencies would occur under level production, and aftertax costs would decline by $31,500, but inventory...

McGregor praises the personal self-awareness that commonly emerged from T-group experiences. To what degree is this sort of intense, interpersonal feedback and shared learning relevant in todays...

McGregor points to group members, more than group leaders, as the key to group or team effectiveness. Do you agree or disagree?

define EFFECTIVE PARTICIPATION