Question: Minimum fluidisation velocity for a specific system depends upon the Particle size Fluid viscosity Density of both the particle & the fluid All ( A

Minimum fluidisation velocity for a specific system depends upon the
Particle size
Fluid viscosity
Density of both the particle & the fluid
All (A),(B) and (C)

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Chemical Engineering Questions!

Q:

The minimum fluidisation velocity (Um) can be calculated using the Ergun equation for fluidised beds, which is given by: Um = dp^2 * (p - f) * g / 150 * * (1 - m) Where: dp = particle diameter =...

Q:

Question 2 [35%] The performance of a fluidised bed reactor in the steam reforming of biomass fast pyrolysis volatiles was investigated at constant temperature of 500C. The reaction can be assumed...

Q:

Question 3 The hydrodynamic drag acting on nano - meter to milli - meter diameter suspended particles in water extracted from a river is to be considered so that their settling time in a 2 m deep...

Q:

Type I settling. Assume that the water temperature is 1 0 C and the settling tank has a 3 - m depth. Calculate the theoretical settling velocity ( m s ) , overflow rate ( m 3 m 2 - d ) , and...

Q:

2. Problem 3.10 (from text book 2nd Ed): In postcapillary venules, leukocytes are close to the vessel wall, rolling or moving slowly than the average fluid velocity Vf. At sites of injury or...

Q:

A catalytic reaction is to be undertaken in a fluidized bed reactor. The rate of reaction is dependent on the surface area of the catalyst, and an investigation of the kinetics of the reaction...

Q:

A compressible flow carries air from a reservoir with 1 MPa through an 834 m pipe with diameter of 90 mm. End of the pipe is 0.8 MPa, and there is an elbow diverting flow to vertical with the same...

Q:

Q 1 . Gasoline flows at the rate of 2 L s through 6 0 mm diameter pipe. Calculate the Reynolds number if density and dynamic viscosity are 7 1 9 k g m 3 and 2 . 9 2 1 0 - 4 P a . s , respectively. [...

Q:

You must predict the performance of a large industrial mixer under various operating conditions. To obtain the necessary data, you decide to run a laboratory test on a small-scale model of the unit....

Q:

Please ONLY solve c . Please provide a correct and neat answer. Upvote! 2) The process water is recycled from the tailing area following the settling of fine particles. The recycled water is to be...

Q:

Under Dunlap's leadership, Scott's stock rose more than 22.5%,making shareholders very happy. Many financial experts believe that maximizing shareholders' welfare must be a corporations overriding...

Q:

Bobs A and B of mass m A and m B (m A >m B ) are connected to an inextensible light string of length I that passes through the smooth ring at C. If bob B moves as a conical pendulum such that A is...

Q:

PA 5 LO 2 . 2 Wachowski Company reported these cost data for the year 2 0 1 7 . Factory maintenance costs $ 9 0 , 0 0 0 Direct labor, wages 3 5 2 , 0 0 0 Direct labor, health insurance 3 2 , 0 0 0...

Q:

A stock had returns of 18.54 percent, 21.88 percent, 15.08 percent, 9.08 percent, and 28.15 percent for the past five years. What is the standard deviation of the returns? Multiple Choice 16.8976:...

Q:

8. Why is money not considered to be a capital resource in economics? Why is entrepreneurial ability considered a category of economic resource, distinct from labor? What are the major functions of...

Q:

LO1.8 (Appendix) Understand graphs, curves, and slopes as they relate to economics.

Q:

LO1.7 Explain how economic growth and international trade increase consumption possibilities.