Modify the single$-$cycle datapath IMAGE ATTACHED by implementing the conditional move instruction

'MOVNZ' $($move$-$if$-$not$-$zero$).$ Below is the syntax. The instruction below will move $t$1$ into $t$0$ if $t$2!=0.$ Otherwise, $t$0$ will be set to $"0".$

MOVNZ $t$0,$ $t$1,$ $t$2$

This is the encoding of the instruction ATTACHED:

Draw the changes on the datapath diagram and provide the values of all the control signals.

IMPORTANT!!!!! FIX IT BY DRAWING ON THE ATTACHED DIAGRAM PICTURE ONLY $($ARROWS$,$DOTS$,$ADDITIONAL TEXT, MULTIPLEXERS, ETC.$)$ TAKE THE ATTACHED DIAGRAM AND DRAW ON IT PLEASE, dont make new images