Question: Mr. Ndugu is using an HC-SR505 PIR motion sensor module in a lab project. Suggest to Mr. Ndugu a proper way to connect this sensor

Mr. Ndugu is using an HC-SR505 PIR motion sensor module in a lab project. Suggest to Mr. Ndugu a proper way to connect this sensor to the Open1768 development board (i.e. to which pins, etc …) and to configure the selected pins! 

 Write a c code and let us assume that Mr. Ndugu wants to detect a rising edge of a signal generated by the sensor over the pin P2.7 (Pin 7 of Port2). later change the c code lines in such a way that the LED0 &LED1 on the Open 1768 development board are switched ON while LED1 and LED2 are switched OFF if a rising edge is detected on pin P2.7


Step by Step Solution

3.44 Rating (147 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock

aThis is the code to detect a rising edge of a signal generated by the sensor over the Pi... View full answer

blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Mathematics Questions!