Question: nee help to connect this Activity 5-2. Wiring Three START/STOP Pushbutton Stations to a Motor Starter In a hard-wired circuit, each component is interconnected using

nee help to connect this
Activity 5-2. Wiring Three START/STOP Pushbutton Stations to a Motor Starter In

Activity 5-2. Wiring Three START/STOP Pushbutton Stations to a Motor Starter In a hard-wired circuit, each component is interconnected using wires that run from component to component. Standard line diagrams provide the information required to hard wire motor control circuits. 1. Using the line diagram, connect the transformer secondary so that it supplies power to the motor starter coil and control circuit. Connect the magnetic motor starter coil so that it operates using any of the three START/STOP control stations. Connect the overload contact of the motor starter. CONTROL STATION 1 CONTROL STATION 2 CONTROL STATION 3 3 STOP 1 STEP-DOWN TRANSFORMER- START STOP Lo START STOP START o STOP STOP 2 HI HO X1 w STOP 3 H2_144 X2 START 1 START 2 0- START 3 STANDARD LINE DIAGRAM Hi APLANEE athei WIRING DIAGRAM 41: Lun-and io toi Lonnred L---- To Noi Lond ALL OLS OVERLOAD CONTACT (4) FROM 230V 30 FUSED DISCONNECT TI 12 230 V. 3 MOTOR n ON OFF COIL

Step by Step Solution

3.40 Rating (162 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock

THE WIRING DIA... View full answer

blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!