Question: Note: Allow minimum x - 1 between each grouping of lines Sheet 2 : Drawing Shapes using pencil On one sheet of paper, draw the

Note: Allow minimum x-1 between each grouping of lines
Sheet 2: Drawing Shapes using pencil
On one sheet of paper, draw the six shapes provided in the DrDT110_Hondout_Assignment_o1.pdf using your paraliel ruler, set squares, and compass or circle template. DO NOT TRACE.
Create each set with pencils
Draft light construction lines to compose the sheet and set of squares to start_Appropriately space the 6 shapes on the sheet.
Draw the outside of the shapes using a dark weight (2B lead).
Use a thin light line for diagonal lines (x in background)(2H Lead).
Use a medium line weight for all other lines and shapes (HB lead)
PART B: SCALE (8.5x11 Paper-portrait orientation)
Instructions
Print out DVDT110_Handout_Assignment_01.pdf on 8.511 poper, and use it to complete this part of the assignment.
Using the scale indicated, measure each numbered line with the appropriate architectural scale (imperial) in the first section and engineers scale (metric) for the last 2 sections. to determine the dimension it represents.
Write your answer in the space provided to the right of each line. Note in feet and inches (ex.5**-6**) Round to the nearest inch for the first section. Note the latter section in mm, cm or M.
You do NOT have to re-draw these lines.
PART C: LETTERING (8.5x11 Paper- portrait orientation)
Instructions
Sheet 3
Letter the alphabet 2 times with 18" high letter (116'' spacing between lines).
Using 18'' high guidelines, print the numbers 0 to 9, plus the following:
Hand write (draft) the Fractions: 12,14,18, and 116.
Repeat the above numbers and fractions using 14-1 high guidelines.
-Use Architectural block letters and numbers for all of the above. Remember that architectural lettering is always uppercase (no lowercase).
Lettering: Text
Sheets 4 and 5(8.5x11 paper-portrait)
Complete this next part on two additional sheets.
Transcribe (reprint) the four paragraphs below (two on one sheet, two on the other) using architectural capital lettering. Each sheet should also contain 1-2 rows of numbers.
Draft within a set of guidelines. Guidelines are seen above and below letters (light 2H pencil lead). Use tools. DO NOT FREEHAND lettering. You may try to draft straight or angled lettering styles or both.
Center lettering on the page, aligned slightly left
Paragraphs 1 and 2 are drafted at 18** high
Paragraphs 3 and 4 are drafted at 14** high
Approximate width of the paragraphs should be 6**
You do NOT need to reprint the bold print titles above the paragraphs:
Note: Allow minimum x - 1 between each grouping

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Civil Engineering Questions!