Note: you can run the code and test the circuit via tinkercad but I will be using the code in an actual arduino uno board so I'll be needing a code that will run in an actual arduino uno board.

Construct the circuit in the figure shown below: UNO SUNOUNDER Using the Serial Monitor as the main input device, control the status of the three LEDs using the corresponding commands: red, yellow, green, off. When a specific LED coloris encoded through the serial monitor, i.e., red; the corresponding LED should turn on. To turn off any LED, the word off should be encoded to the serial monitor. Create an interface in the Serial Monitor so that it becomes interactive to use. You may include Activa introductory messages for example. Go to s