Part II: Learning Interface Defaults

Objective I: Study Ethernet defaults

Enter a command on Router that reports the status and parameters of the interface GigabitEthernet0/0.

Whats the interfaces Physical and Data Link layers default state? Interpret the state shown.

Is the MAC address shown?

What are the IP address and subnet mask? Whats the MTU size?

Whats the interfaces default bandwidth and delay?

Write the command and answer questions in the laboratory report

i need the command only which I spouse enter so i can answer the question for the report thank you

Part II: Learning Interface Defaults

Objective I: Study Ethernet defaults

Command entered:

Physical layers default state (as shown):

Interpretation of the L1 state:

Data Link layers default state (as shown):

Interpretation of the L2 state:

Is the MAC address shown (yes/no)?

Default IP address and subnet mask (if any):

Default MTU size (bytes):

Default parameters: Bandwidth (Kbps): Delay (s):