Question: Please Answer fast A venturi meter is to be installed in a 100-mm line to measure the flow of water. The maximum flow rate is

Please Answer fast A venturi meter is to be installed in

Please Answer fast

A venturi meter is to be installed in a 100-mm line to measure the flow of water. The maximum flow rate is expected to be 75 m/h at 15C. The manometer used to measure the differential pressure is to be filled with mercury, and water is to fill the leads above the surfaces of the mercury. The water temperature will be 15C throughout. (a) If the maximum manometer reading is to be 1.25 m and the venturi coefficient is 0.98, what throat diameter, to the nearest millimeter, should be specified for the venturi? (b) What will be the power to operate the meter at full load if the pressure recovery is 90 percent of the differential pressure

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Chemical Engineering Questions!

1. What is the advantage of using variable area rotameter? 2. Identify the plane of reading of following Rotameter float 3. wnat is the power requirement of venturimeter and orificemeter? 4. A...

How to solve A venturi meter is to be installed in a Schedule 4 0 4 - in . line to measure the flow of water. The maximum flow rate is expected to be 3 2 5 gallons per minute at 6 0 ' F . The 5 0 -...

5. A venturi meter is to be installed in a sch. 40 4 inch line to measure the flow of water. The maximum flow rate is expected to be 325 gal/min at 60 F. the 50 in manometer used to measure the...

Ground coal is slurried with water in a pit, and the slurry is pumped out of the pit at a rate of $500 \mathrm{gpm}$ with a centrifugal pump and into a classifier. The classifier inlet is $50...

After the installation of the orifice meter of Example 8.4, the manometer reading at a definite constant flow rate is 45 mm. Calculate the flow through the line in m 3 /h measured at 15C. Exercise...

Solid particles with a density of $1.4 \mathrm{~g} / \mathrm{cm}^{3}$ and a diameter of $0.01 \mathrm{~cm}$ are fed from a hopper into a line where they are mixed with water, which is draining by...

PLEASE ANSWER ONLY NUMBER 10 PLEASE Stream Velocity and Discharge Exercise - Week 14 For this exercise, you will be watching a demonstration of the Sontek FlowTracker and answer the 10 questions at...

need help fast please A pump takes water at 70F from a large reservoir and delivers it to the bottom of an elevated pressurized tank (P= 15 psig) through a 2.5-in Schedule 40 pipe. The inlet to the...

a. Example 13-1: Batch Reactor with an Exothermic Reaction Wolfram 1. Adiabatic Case: Use Wolfram to see whether you can find a trajectory that is ready to ignite and whose trajectory looks like a...

Chestnut Case Questions: Note: Use the following questions to guide your case analysis report, which should be a complete piece of work. Follow the instructions about format on the syllabus. Further,...

Greenwave, Inc., went public 5 years ago and has had no further equity issuance (or repurchases of equity). The firm has the following current balances for its book value of equity: Par Value ($2.00...

The Youngsun Kim Company has a capitalization of 20,000, $1.60 no par value preferred shares and 40,000 no par value common shares. All the authorized shares have been issued. The preferred shares at...

The \ ( 2 0 \ times 9 \ ) condensed SCI and the \ ( 2 0 \ times 9 \ ) and \ ( 2 0 \ times 8 \ ) condensed SFP for Georgian Ltd are shown below All sales are on credit The company s income tax rate is...

1a-f) Multiple Choice: Select the best answer and write it on the blank. Also provide the specification for the language. (28pts) Which specification technique would be the weakest (least powerful;...

What is the value of the positive-negative ratio at its highest point?

What do you notice about the count of positive and negative words compared to the total word count? How might this comparison impact your conclusions?

Which types of analytics are useful in tax planningdescriptive, diagnostic, predictive, or prescriptiveand why?