please be discriptive program the devices using ... Question: Please be discriptive Program the devices using th... please be discriptive Program the devices using the following symbols, descriptions, and addresses

: I/O Symbol Description Address

Input L_S NO LS I:0/0

Input S_1 NO MC PB I:0/1

Input S_2 NO MC PB I:0/2

Input S_3 NO SS I:0/3

Input S_4 NO SS I:0/4

Input CP_S NO PS I:0/5

Input FP_S NO PS I:0/6

Input IP_S NO PS I:0/7

Output M_R Motor Relay O:0/0

Output L_1 -Red PL O:0/1

Output L_2-Green PL O:0/2

Output L_3 Blue PL O:0/3

In this lab you will be automating the operation of the conveyor system using advanced instructions. The program is required to operate as follows: - Pushbutton S_1 is used to manually latch (M_R ON) and unlatch (M_R OFF) the conveyor. - The fiber optic sensor FP_S detects the TOTAL parts that go through the line. - The inductive sensor IP_S detects the METAL parts that go through the line. - The limit switch L_S momentarily stops the conveyor (M_R OFF). - The red pilot light L_1 must be ON when the METAL part count is greater or equal than the NONMETAL part count and the TOTAL count is greater than 0. - The green pilot light L_2 must be ON when the METAL part count is less than the NONMETAL part count and the TOTAL count is greater than 0. - The blue pilot light L_3 must flash ON and OFF when the TOTAL count is larger than 0 in intervals given by the following relationship in milliseconds: FLASHING = 1050 (1000*METAL)/TOTAL - Pushbutton S_2 must reset all counts to 0. - DO NOT use counters for this control process. Instead use ADD and SUBTRACT instructions for the METAL, NONMETAL, and TOTAL counts. - HINT: the value of FLASHING must be calculated as a separate integer value (N7:X) and moved (MOV) to the PRESET values of the flashing timers. 3 Download and Test the program (not possible when working remotely): - Double-Click on the Channel Configuration item within the Controller folder of the Program Organizer pane on the left. - Select the Channel 1 tab and enter the correct controller IP address (168.254.224.XX) listed on the RSWho Window. - Enter the appropriate Subnet Mask (255.255.0.0). - Disable the BOOTP Enable and DHCP Enable options and click OK. - Save the .RSS program file. - From the Comms menu select System Comms. Select the appropriate controller under the AB_ETHIP-1 driver and click Download. - Note: do not click Upload or your program will be replaced with the one currently in the controller memory. - From the Comms menu select Mode > Run. Your program is now running directly on the controller. - With the help of the instructor, test your program by experimenting the different I/O alternatives. - Back on your workstation, select Mode > Program and Go Offline from the Comms menu