PLEASE DO NOT COPY CODE FROM PREVIOUS ANSWERS:

write C code according to the following prompt:

$(1)$

Program the AHB$2$ENR register to enable the clock of GPIO Port A$.$

RCC$->$AHB$2$ENR

$(2)$

Program the port A mode register $($MODER$)$ to set Pin $5$ as output

GPIOA$->$MODER

$(3)$

Program the port A output type register $($OTYPER$)$ to set Pin $5$ as push$-$pull.

GPIOA$->$OTYPER

$(4)$

Program the port A pull$-$up$/$pull$-$down register $($PUPDR$)$ to set Pin $5$ as no$-$pull$-$up no pull$-$down.

GPIOA$->$PUPDR

$(5)$

Program the port A output data register $($ODR$)$ to set the output of Pin $5$ to $1$ or $0,$ which enables or disables the LED, respectively.

GPIOA$->$ODR

To output a high voltage $(3\mathrm{.}0$V$)$ on pin $5,$ simply set bit $5$ of ODR to $1.$

$(6)$

At the end of your code, include an infinite loop to prevent the code from executing beyond the end of the program.

while$(1)$;