Please put the solution in an question-answer order

Like: Option 1: xxx Option 2:xxx and so on.. Much appreciated!

Ps. Could you please tell what kind of software you are using just in case?

Thank you.

As shown in Fig. 1, an organization has two network sites connected by the routers FLRSiteA and FLRSiteB as shown in the diagram below. The organization can use the block of 192.168.140/24 for its network. You are required to create an addressing scheme that will allow each network segment to have 20 hosts. 1 TASK 1: Create the given topology. SITE A SITE B wok VESS PG CI PCS PCI PCS udjecuve: Note: Use Router 2911 and Switch 2960. Make sure you label the network components according to the naming format given. Use cross over cable (-) and straight through cable appropriately. Output 1: Network Topology Created. Output 2: Subnetting Scheme Network Subnet Mask IP Addresses Usable Range Comment Broadcast Address *Add required number of columns and rows. Output 3:IP Address Assignment I *Add required number of columns and rows. Output 4: Start-up Configuration (Device Name) * Add as many output box as required. **Device Name : Router/Switches used in the network topology Analysis/ Discussion/Conclusion Output 1 Output 2 Output 3 Output 4