Problem 1 of 2 [60 points] a. Create a hand drawing on a blank sheet with all necessary orthographic views of the object shown below, using your geometry set and compass. Make sure the views are properly aligned. Dimensions are given in mm. Pay attention to line weights and line types. b. Include all dimensions. Make sure not to duplicate any. c. Add the following linear tolerances: [30 points] [8 points] [6 points] for the width of the internal notches +0.1/-0.0, as unilateral tolerance for the length of the faces of the hexagon 0.1, as limit tolerance d. Add the following datums and geometric tolerances: the bottom face is datum A [16 points] 35 the shortest face of the hexagon is datum B the shortest face of the hexagon is perpendicular to datum A within 0.1 the longest face of the hexagon is parallel to datum B within 0.1 60 2 PLACES 30 050 80 REGULAR HEXAGON 80 ACROSS THE CORNER 1 15 12-4 PLACES