Problem 28 Question Help An automatic the produces rollers for roter beings, and the process is monitored by statistical process control charts. The contraline of the chart for the sample means is so at 8.50 and for the mean range at 0.29 mm. The process is in control, as established by samples of 6. The upper and lower specifications for the diameter of the rolors are (8.50 +0.35) and (8.50 -0.35)mm, respectively Click the icon to view the table of factors for calculating three-sigma mis for the x-chart and R.chart. a. Calculate the controllimis for the mean and range charts The UCL 0.5 mm and the LCL 0 mm (Enter your responses rounded to two decimal places) The UCL, quas 8.04 mm and the LCL, quas 8.36 mm. (Enter your responses rounded to two decimal places) b. W the standard deviation of the process distribution is estimated to be 0.16 mm, in the process capable of meeting specifications? Assume four-sigma quality A Yes, because a greater than the critical value of 133 3. No, because is less than the critical value of 133 C. Yes, because is less than the critical value of 133 OD. No, because is greater than the critical value of 133 Enter your answer in the answer box and then click Check Answer. D. No, because is greater than the critical value of 133. 2. If the process is not capable, what percent of the output will fall outside the specification limits? (Hint Refer to the standard romal table.) (Enter your response rounded to two decimal places Typen there is no solution) Enter your answer in the answer box and then click Check Answer Clear All Check Answer All parts showing SPM 002 o PSC F12 F10 FO F8 F5 F7 F6 F4 F3 % &