Problem 3-124\ The table lists the maximum and minimum hole and shaft dimensions for a variety of standard press and shrink fits. The materials are both hot-rolled steel. Find the maximum and minimum values of the radial interference and the corresponding interface pressure. Use a collar diameter of

100mm

for the metric sizes and 4 in for those in inch units.\ \\\\table[[\\\\table[[Problem],[Number]],Fit,Designation,\\\\table[[Basic],[Size]],Hole,Shaft],[

d_(min)

,,,],[

3-124

,

50H(7)/(p)6

,

50mm

,50.025,50.000,50.042,50.026,]]

The table lists the maximum and minimum hole and shaft dimensions for a variety of standard press and shrink fits. The materials are both hot-rolled steel. Find the maximum and minimum values of the radial interference and the corresponding interface pressure. Use a collar diameter of 100mm for the metric sizes and 4 in for those in inch units