Question: A slender rod is 80.0 cm long and has mass 0.120 kg. A small 0.0200 kg sphere is welded to one end of the

A slender rod is 80.0 cm long and has mass 0.120 kg.

A slender rod is 80.0 cm long and has mass 0.120 kg. A small 0.0200 kg sphere is welded to one end of the rod, and a small 0.0800 kg sphere is welded to the other end. The rod, pivoting about a stationary, frictionless axis at its center, is held horizontal and released from rest. What is the linear speed of the 0.0800 kg sphere as its passes through its lowest point? Express your answer with the appropriate units.

Step by Step Solution

★★★★★

3.54 Rating (151 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

Given that Slender rod Length of rod80cm08m Mass of slender rod012kg Sphere Bob at one end Mass M100... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Physics Questions!

The 120-N force is applied as shown to one end of the curved wrench. If a = 30, calculate the moment of F about the center O of the bolt. Determine the value of a which would maximize the moment...

A guitar string is 90 cm long and has a mass of 3.6g. The distance from the bridge to the support post is L = 62cm and the string is under a tension of 520 N. What are the frequencies of the...

A small ball is attached to one end of a spring that has an unstrained length of 0.200 m. The spring is held by the other end, and the ball is whirled around in a horizontal circle at a speed of 3.00...

Sir Lost-a-Lot dons his armor and sets out from the castle on his trusty steed in his quest to improve communication between damsels and dragons (Fig. P12.20). unfortunately his squire lowered the...

An athlete at the gym holds a 3.0 kg steel ball in his hand. His arm is 70 cm long and has a mass of 3.8 kg, with the center of mass at 40% of the arm length. What is the magnitude of the torque...

With particular experimental methods, it is possible to produce and observe in a long thin rod both a longitudinal wave and a transverse wave whose speed depends primarily on tension in the rod. The...

Suppose that the rod in Fig. 17.23a is made of copper, is 45.0 cm long and has a cross-sectional area of 1.25 cm2. Let TH = 100.0oC and Tc = 0.0oC. (a) What is the final steady-state temperature...

One end of an insulated metal rod is maintained at 100.0oC, and the other end is maintained at 0.00oC by an ice-water mixture. The rod is 60.0 cm long and has a cross-sectional area of 1.25 cm2. The...

In Fig 21-12, the rod moves with a speed of 1.6 m/s, is 30.0 cm long, and has a resistance of 2.5 . The magnetic field is 0.35 T, and the resistance of the U-shaped conductor is 25.0 at a given...

Figure shows a bar magnet suspended by a thin wire that provides a restoring torque -??. The magnet is 16 cm long, has a mass of 0.8 kg, a dipole moment of ? = 0.12 A???m2, and it is located in a...

Personal property in the form of chattels is portable. Proving and tracking ownership and possession are challenging. Should we establish a comprehensive system of registering all chattels as we do...

Holly purchased a house in 1999 for $390,000 (of which $40,000 is for the land). In April 2019 she decided to relocate to another state. She did not sell her house and converted the property into a...

Which of the following is NOT a requirement under the Sarbanes - Oxley Act? Option A Companies must establish internal controls to prevent fraud. Option B CEOs and CFOs must certify the accuracy of...

1. What are some of the key human resource challenges that low and middle income countries face in staffing and operating their health systems?. What are YOUR thoughts about what you read? 2. What...

Differences between domestic and international human resource management (HRM), This is due to international organizations being required to address three different employee types or categories;...

Illustrates 5 Key trends that are fundamentally transforming IT leadership, each of these points are very salient. However, a great deal of dialogue is on-going among both IT professionals and...

The number of system breakdown occurring with a constant rate in a given length of time has a mean value of two breakdowns. What is the probability that in the same length of time, two breakdowns...

Redtop Co. uses a standard cost system and flexible budgets. The following flexible budget was prepared at the 80% operating level for the year: Standard direct labor hours (DLHs) 28,800 Budgeted...

Assume your company's capital structure is 75% equity and 25% debt. The bank will loan you money at 6% interest, net of tax, and your only shareholder wants to achieve at least a 20% return on her...

a) The pendulum consists of a disk having a mass of 5.5kg and slender rods AB and CD which have a mass per unit length of 2k(g)/(m) as shown in Figure Q1(a). Determine;\ i) the length L of AB so that...

1. Mass moment of inertia The assembly is made of the slender rods that have a mass per unit length of 3 kg/m. Determine the mass moment of inertia of the assembly about an axis perpendicular to the...

Graphics from Slides: Here are several still images from slides of different useful equations. 1D Motion Physics is Calculus S position V velocity a acceleration I time differentiate differentiate S...

A slender rod is being pulled by a rope that passes through pulley A. The rod has a mass of 45 kg. (a) Sketch the free body diagram of the rod. (b) Determine the angular acceleration of the rod. (c)...