Provide detailed STEP BY STEP 100% Correct Solution....this Question has Subparts from A to R part solve all and show your calculations

The thickness of the outside layer in a manufacturing process. The table contains thickness measurements on 20 subgroups of 5 readings each. Assume that you want to analyze using an schart. a-) What is the LCL for the X control chart? (use 2 decimals) b-) What is the UCL for the X control chart? (use 2 decimals) c-) What is the LCL for the s control chart? (use 2 decimals) d-) What is the UCL for the s control chart? (use 2 decimals) e-) Check the sample data value with the calculated control limits value. Is the process in control? f ) If NO (the process is not in control), which sample is out of control limits: g-) What is the revised LCL for the X control chart? (use 2 decimals) h-) What is the revised UCL for the X control chart? (use 2 decimals) i-) What is the LCL for the revised s control chart? (use 2 decimals) j-) What is the UCL for the revised s control chart? (use 2 decimals) k-) b) After revision, what is the estimated value of the process mean? (use 2 decimals) 1-) After revision, what is the estimated value of process standard deviation? (use 2 decimals) After revision, what is the estimated value of process standard deviation? (use 2 decimals) If the quality characteristic is normally distributed and if the specifications are 17930, what is the potential process capability (Cp) ? n-) According to the calculated Cp value in part ' m ', can the process meet the specifications? 0) If the quality characteristic is normally distributed and if the specifications are 17930, what is the lower process capability (Cpl) be)? (use 2 decimals) p-) ( If the quality characteristic is normally distributed and if the specifications are 17930, what is upper process capability (Cpu) be)? (use 2 decimals) q-) If the quality characteristic is normally distributed and if the specifications are 17930, what is the actual process capability (Cpk) be)? (use 2 decimals) According to the calculated process capability ratio values above, what percentage of the specification band is used up by the process? (use 2 decimals)