Question: Q 1 . Design a process to fabricate a poly Silicon cantilever beam as shown in the figure. Draw the cross section of each step

Q1. Design a process to fabricate a poly Silicon cantilever beam as shown in the figure. Draw the cross section of each step including the mask you need. (10pts) Silicon Substrate
For this I need step-wise full drawings
Q 1 . Design a process to fabricate a poly

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Q:

Consider a gold covered cantilever with the cross section shown on Figure 1. Note that the beam is fabricated using a three mask process (anchor etch, polysilicon etch, gold etch). The thicknesses of...

Q:

I need a Gantt chart or similar timetable briefly outlining what & when you will be doing, and more description on the process you will be following to complete these tasks. E.g. Pre-degradation...

Q:

PXT992 Research Project Plan Degradation Mechanisms in Quantum Dot on Silicon Lasers Author 1 Purpose (motivation) One of the most urgent issues in semiconductor technology is the direct development...

Q:

Draw a total setup outline and decide the expense for the most economical design, i.e., the one where the complete expense of the correspondences circuits and equpment is the least. (b) The...

Q:

3.10 For the following process steps, assume that you use a positive photoresist and that etch selectivity is infinite. A composite plot of four photomasks is given in Fig. 3-26. Assume that mask...

Q:

A simply supported reinforced concrete beam with a cantilever shown in Figure 2 (1= 5 m, 1-1 m, X =1.5 m) carries the following loads: Its own weight; w= 10kN/m; wp=15 kN/m; Qo=25 kN, and Q = 16 kN....

Q:

Developments in Technology Light is incident from air on the end face of a multimode optical fibre at angle of incidence as shown below. n n 1 2 The refractive indices of the core and cladding are...

Q:

BACKGROUND An SM bond is a 35-year Australian government bond with a face value of $1. They are marketed to consumers saving for retirement (who buy the S part) and investors (who buy the M part)....

Q:

please help with below question as per the attached article on Using Supply Chain Analysis to Examine the Costs of NonTariff Measures (NTMs) : Michael J Ferrantino, WTO 1. Critically examine the...

Q:

10.255.255.255.ii (ii) Describe the advantages of the paired de Bruijn Graph versus the non paired version of the de Bruijn Graph. [3 marks] (d) Discuss the advantages of using soft k-means versus...

Q:

if you burn 40 g of oil and produce 30 g of carbon dioxide, what is the total mass of all the products produced from the buming of this O 30 g O less than 40g O More than 40 g O 40 g

Q:

At equilibrium in the following figure, what area(s) represent consumers surplus? producers surplus? 0 10 20 30 40 50

Q:

What is the total return obtained from all five projects? $ 8 6 0 , 0 0 0

Q:

A 6,000 2,454.99 3B 6,000 1,463.41 5C 6,000 1,851.85 4 Loan rates of interest Personal Finance Problem John Flemming has been shopping for a loan to finance the purchase of a used car. He has found...