Question: Question 1 10 pts When configuring an EtherChannel manually, how many steps must be followed? 05 10 02 03 Question 2 10 pts An engineer

Question 1 10 pts When configuring anQuestion 1 10 pts When configuring anQuestion 1 10 pts When configuring an

Question 1 10 pts When configuring an EtherChannel manually, how many steps must be followed? 05 10 02 03 Question 2 10 pts An engineer needs to define the load distribution method as the source IP address. Which command could this engineer use? Oport-channel load balance dst-ip O port-channel load-balance src-ip O port-channel load balance src-dst-ip O port-channel load balance ip-src Question 3 10 pts An engineer would like to define the load distribution method as the destination TCP or UDP port. Which command should this engineer use? O port-channel load balance dst-top-udp O port-channel load balance dst-port Oport-channel load-balance dst-src-port O port-channel load-balance dst-top-udp-port Question 4 10 pts When transmitting messages on VLAN trunks, which method sends the messages in the native VLAN with no VLAN header/tag? O MSTP RPVST ORPVST+ ORSTP Question 5 10 pts What is the difference between EtherChannel auto and desirable modes? Auto will always try to negotiate to an access port first before trying other modes. Auto mode will not function and put the port into errdisable mode unless both sides of the link are in auto. Auto will always initiate autonegotiation, whereas desirable will not. Desirable will always initiate autonegotiation, whereas auto will not. Desirable mode will not function and put the port into errdisable mode unless both sides of the link are in desirable. U Question 6 10 pts An engineer wants to define the load distribution method as the source MAC address. Which command should the engineer use? load-balance port-channel src-mac O port-channel load balance mac-add load-balance port-channel mac-add Oport-channel load balance src-mac Question 7 10 pts What is the only way an engineer can alter the value of the bridge ID? Modify the main switch MAC address Swap out the main switch network interface card Configure the STP priority Configure the bridge ID under STP configuration mode U Question 8 10 pts Which EtherChannel mode should be used if the intention is to have the targeted interfaces initiate a connection via LACP? Active mode Passive mode O Desirable mode O Auto mode Question 9 10 pts Which of the following terms is not synonymous with the others listed? ChannelGroup CiscoChannel PortChannel EtherChannel

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related General Management Questions!