Question 10

Which type of address does a switch use to build the MAC address table?

a)	source MAC address

b)	destination IP address

c)	source IP address

d)	destination MAC address

Question 11

Which statements are not true about using full-duplex Fast Ethernet? (Choose all that apply.)

a)	Performance is improved with bidirectional data flow.

b)	Full-duplex Fast Ethernet offers 100 percent efficiency in both directions.

c)	Nodes operate in full-duplex with unidirectional data flow.

d)	Latency is reduced because the NIC processes frames faster.

e)	Performance is improved because the NIC is able to detect collisions.

Question 12

A production switch is reloaded and finishes with a Switch> prompt. What are incorrect? (Choose all that apply.)

a)	The boot process was interrupted.

b)	A full version of the Cisco IOS was located and loaded.

c)	POST occurred normally.

d)	The switch did not locate the Cisco IOS in flash, so it defaulted to ROM.

e)	There is not enough RAM or flash on this router.

Question 13

What is one function of a Layer 2 switch?

a)	forwards data based on logical addressing

b)	duplicates the electrical signal of each frame to every port

c)	learns the port assigned to a host by examining the destination MAC address

d)	determines which interface is used to forward a frame based on the destination MAC address

Q14:As the traffic is untagged when crossing a trunk port, which type of VLAN is used?

a)

data

b)

default

c)

native

d)	management

e)	None of the above