Question: Question 14 options: In machining cell with one operator, the longest machine cycle time is calculated which is 300 seconds, while the operator cycle time

Question 14 options: In machining cell with one operator, the longest machine cycle time is calculated which is 300 seconds, while the operator cycle time is 250 seconds. From this information, the actual cycle time for this machine cell is minutes per unit. Assume the available time is 400 minutes per day. The capacity of this cell is

units/ day

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related General Management Questions!

In machining cell with one operator, the longest machine cycle time is calculated which is 300 seconds, while the operator cycle time is 250 seconds. From this information, the actual cycle time for...

2. The manufacturing cell shown in table above has seven machines and can be manned by one or two operators. These operators can work at any machine in the cell. Each of the machines is at least...

5. The following data are for a master cylinder machining process with one operator. Manual times are in seconds. The machines are all SCAS. Part Number: 1234M56G78 Regular Workday: 460 minutes...

The Production Capacity Chart (or Process Capacity Table) only focuses on a single process Question 13 options: True False Cycle time must not be more than Takt time Question 14 options: True False...

Please help with this one!! Mini-Case 1 TWI Industries 4 Adapted from Learning to See Version 1.3, by Mike Rother and John Shook, Lean Enterprise Institute, Inc. (Cambridge, MA) June, 2003. Used with...

Mini-Case 1 TWI Industries 4 Steering Arm Value Stream: Future State In the current state, the Steering Arm Value Stream shop floor was swamped with orders due to the long lead times. Because of the...

Case Introduction to the Facility The 200,000 sq. ft. facility shown in Figure 1 has been manufacturing flanges in Indianapolis, IN for the past 50 years. Figure 1. Flange Factory Flanges are bolted,...

Case Introduction to the Facility The 200,000 sq. ft. facility shown in Figure 1 has been manufacturing flanges in Indianapolis, IN for the past 50 years. Flanges are bolted, steel plates used to...

You must write one well written descriptive paragraph. It must have three arguments to support your main thesis. There should also be an introductory sentence. As well as a closing and definitive...

Balance sheet data for Brimstone Company follows: a. Determine the working capital and current ratio for 2016 and 2015. b. Does the change in the current ratio from 2015 to 2016 indicate a favorable...

2. Understanding the steps in the accounting cycle is important to get accurate information about the financial condition of your company. In teams, make strips of paper with the nine steps of the...

When older adults have difficulty with transportation and communication, or may be reluctant to request needed assistance to which they are entitled, they may be in need of: Group of answer choices...