Question: Question 2 (a) A 10 station in-line assembly machine has a 6-s ideal cycle time. The base part is automatically loaded prior to the first

Question 2 (a) A 10 station in-line assembly machine has a 6-s ideal cycle time. The base part is automatically loaded prior to the first station. The fraction defect rate at each of 10 stations is equal to 0.01 and the probability that a defect willjam is 0.5 when jam occurs, the average down time is 2 minutes. Determine the average production rate, the yield of good assemblies, and the uptime efficiency of the assembly machine. (6) Discuss automated assembly line based on physical configuration: (1) Dial type assembly machine In-line assembly machine Carousel assembly system (iv) Single-station assembly machine

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related General Management Questions!

A twelve-station in-line assembly machine has an ideal cycle time = 10 sec. The base part is automatically loaded prior to the first station, and components are added at each of the stations. The...

(3 pt.) A twelve-station in-line assembly machine has an ideal cycle time = 10 sec. The base part is automatically loaded prior to the first station, and components are added at each of the stations....

2.2 An eight-station automatic assembly line runs 5000 hr/yr and has an ideal cycle time of 12 sec. Downtime occurs for two reasons. First, mechanical and electrical failures cause line stops that...

Question 2! VIMU TRAI HA h M 12 50 100 30 24 1 50 40 6 10 80 Question 2 (a) A 10 station in-line assembly machine has a 6-s ideal cycle time. The base part is automatically loaded prior to the first...

Question 5 (a) Discuss automated assembly line based on physical configuration: (i) Dial-type assembly machine (ii) In-line assembly machine (iii) Carousel assembly system (iv) Single-station...

\f3nd Lecture What's cause production performance go south? VARIABILITY ASSESSMENT & ITS IMPACT 1 Books for this class 2 From previous lecture We learn about a method to evaluate the production...

Read the text in the images above and answer the following question: What is the importance of good leadership practices in a production system? Discuss the examples of good leadership found in the...

Provide a summary technical report with your own words about Pipelined Execution which is also named as Instruction Level Parallelism, addressing mainly the following areas: 1. What is Pipelined...

Question: How would cost-plus pricing change continuous improvement at Kenco? (10 marks) Compare and explain fully the strategic and operational implications of cost-plus pricing versus Kencos...

Question: Describe Kencos CI system; compare this to process change using traditional budgeting Abstract This case illustrates a strategy-driven costing system combining ideas from lean management...

The offset slider crank mechanism is shown in the figure when 02-120 and constant angular velocity is o2=18 rad/s cw. The masses and mass moment of inertia of the links are m2=2.5 kg, m3-7.4 kg,...

The article Readability of Liquid Crystal Displays: A Response Surface (Human Factors [1983]: 185190) used an estimated regression equation to describe the relationship between y = error percentage...

Thoroughly wash up immediately after exposure Use the appropriate disinfectant. Report the exposure to a supervisor Wear the appropriate PPE to protect yourself. Report the exposure to a 3 2 4 Clean...

As the manager of Smith Construction, you need to make a decision on the number of homes to build in a new residential area where you are the only builder. Unfortunately, you must build the homes...