Question$-3(10$ points$)$

Find the shaft diameter in Fig. $3$ if the allowable deflection is delta $mm.$ use Matlab to confirm your calculations. See table $1$ to get the values for $F_1,F_2,F_3$ in $KN,$ and all dimensions for delta $,1,2,3m.$

Question$-4(20$ points$)$

Your are required to design the $C-$clamp as shown in Figure $4.$ Take $d_0=24,$ pitch $=mm($See table $1$ to get the values for $H^{,inmm}).$ check the buckling of the screw. Us Matlab to confirm your calculations. Also, draw an assembly drawing.

Parts list

$\backslash$table$[[$SI$.$ No$.,$Name,Matt.,Qty$.],[1,$Frame,Cl$,1],[2,$Screw,MS$,1],[3,$Pad,MS$,1],[4,$Tommy bar,MS$,1],[5,$Collar,MS$,1],[6,$Pin,MS$,1],[7,$Cap screw,MS$,1]]$

See Next Page

$\frac{2}{4}$