Refer to Table 86.1-Facters for Computing Control Chart Limits.(3.sigmo) for this problem. Sampling 4 pieces of precision-cut wire to be used in computer assembly) every hour for the past 24 hours has produced the following results: R Hour Hour 1 2 3 4 5 6 x 3.25 3.10 3.12 3.39 3.17 2.96 0.71" 1.13 1.38 1.31 1.22 0.32 7 8 9 10 11 12 x R 3.15* 0.58 2.75 1.13 3.12 0.66 2.95 1.38 2.73 1.22 3.07 0.35 Hour 13 14 15 16 17 18 X R 3.01" 0.90 2.73 1.36 3.12 1.06 2.84 0.50 2.76 1.48 2.84 1.24 Hour 19 20 21 22 23 24 XSNN x 4.51" 2.89 2.65 3.18 2.84 2.74 R 1.56" 1.14 1.13 0.51 1.58 0.92 Based on the sampling done, the control limits for 3-sigmax chart are (round all intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCL) - inches (round your response to three decimal places) Lower Control Limit (LCL) - inches (round your response to throw decimont plooms) Based on the x-chart, the wire cutting process has been The control imits for the 3-sigma R chart are found all intermediate calculations to throw decimal places before proceeding with further caniculations): Upper Control Limit (UCLA) - inches (round your response to three decimal placos), Lower Control Limit (LCR) - inches (round your response to three decimal place) Based on the chart, the wire cutting process has been