Refer to Table S6 1 - Factors for Comouting Control Chart Limss ( 3 sigma) for this problem. Auto pistons at Wemming Chung's plant in Shanghai are produced in a lorging process, and the diameter is a critical factor that must be controlled. From sample sizes of 10 pistons pe mean and the rarge of this diameter have been as follows: a) What is the value of x ? x=mm (round your response to two decimal ploces). Definition b) What is the value of R ? R= min (round your response to two decimal places). c) What are the UCL; and LCL, x using 3 -sigma? Upper Control Limit ( UCL, Lower Control Limst (LCi)=mmn (round your response to two decimal places) 6) What are the UCLR and LCLR using 3-sigra? Uppor Control Lm2(ULLR)=mm (round your response to two decima ploces) Lowor Consici Lime (LCLR) = Inen (round your response to two decima places), e) If the true diameter moan should be 155mm and you want this a your contoc (nomman Upper Contiol Linet (UCy)=1rm (round your response to two docima places). Lowor Control tmin ((ax)= min iround your response to tho desimal passes)