Scaling VLANS $($VTP$,$ STP and DTP$)$

Problem $2$: Configuring PVST $+$

In this activity, you will configure VLANs and trunks, and examine and configure the Spanning

Tree Protocol primary and secondary root bridges. You will also optimize the switched topology

using PVST $+,$ PortFast, and BPDU guard.

Create VLANs $10,20,30,40,50,60,70,80,$ and $99$ on all of the switches.

Assign VLANs to switch ports according the following table:

Configure ports $F\frac{0}{1}$ to $F\frac{0}{4}$ on each switch as trunk ports, and assign these trunk ports to

native VLAN $99.$

Configure the management interface on all three switches with an address according to the

following table. Verify that the switches are correctly configured by pinging between

them.

Configure S $1$ to be the primary root for VLANs $1,10,30,50,$ and $70.$ Configure $S3$ to be

the primary root for VLANs $20,40,60,80,$ and $99.$ Configure S$2$ to be the secondary root

for all VLANs.

Configure PortFast and BPDU guard on the switches.

Verify your configuration.I$\text{'}$m