Send all answer by using Flexsim $.$ On before paint area assembly line in a compary $5$ different parts are assumbled. Parts are transported by an automsted conveyor $[$max speed $5\frac{m}{m}in$ system. Pait $1$ and $4$ are corring directly on assembly line while parts $2,3$ and $5$ are procersed bofore getting assembled for $4,4$ and $5$ minutes respectively. After assombly, a forkift $($max speed $10\frac{m}{m}in)$ is carrying two assemblies at a time, up to the shipping point. Each assembly takes $4$ minute to complete, Raw material arrival is as indicated here:

$\backslash$table$[[$Resonrce$,$Arrival time$],[$Part $1,$Exponential $(0,5,0)$ Minutes$],[$Part $2,8$ Minutes$],[$Part $3,7$ Minutes$],[$Part $4,$Exponental $(0,7,0)$ Minutes$],[$Part $5,8$ Minutes$]]$

Find:

$1.$Throughput of shop floor. $($Run time: see from the sheet provided an gleare portal$).$

$2.$ Find Utilization of resources.

$3.$ Suggestions for optimizing the shop floor