Test Your Knowledge Name Write your answers in the spices provided 1. Which is not a common type of drawing? A. Mechanical plan B. Plumbing plan C. Painting plan D.Foundation plan E. They are all common drawings 2. Under what conditions can the electrical plan be included on the floor plan? A. When the building is a smaller job or a residential project B. When print paper is scarce C. When the architect is also an electrician D. When a single company is doing all the construction E. There are no conditions when the electrical plan can be included on the floor plan 3. Which drawing would show the location of a building sprinkler system? A. Electrical plan B. Foundation plan C. Site plan D. Plumbing plan E. A building sprinkler system would not be shown on any of these drawings 4. Which occupation does not need to know how to read construction prints? A Welder B. Construction estimator C. Owner of a lighting store D. Concrete supplier E. All of these occupations require print reading 5. A list of materials included on a drawing is called A notes B. an elevation C. a section D. a schedule E. None of the above. 6. True or False A rendering would show all the details needed to build an office building 7. True or False? The locations of utilities are generally shown on the site plan. 8. True or False? Most construction drawings are created using orthographic projection. F 9. True or False? Prints will not be damaged if they are left out in direct sunlight for an extended period. T 10. True or False? Working drawing is another term for print D 11. In a set of working drawings, under which drawing classification would the steel framing be found? A. Civil drawings B. Architectural drawings C. Plumbing drawings D. Structural drawings E. Mechanical drawings 12. Which type of schedule would identify the required floor material? A. Door schedule B. Room finish schedule C. Column schedule D. Wall schedule E. Floor schedule 13. True or False? When first opening a set of drawings, you should review the floor plans to visualize what the building is going to look like when it is finished. E 14. True or False? Drawings made in CADD are created at reduced size and plotted at the appropriate scale. 15. When handling prints, when is it acceptable to write on them? When estimating the project cost B. When noting the name of a supplier C. When there is no other paper available D. It is always acceptable to write on prints as long as it is with a pencil. 17 Goodheart Wilcox Co Inc