The answers here are wrong. You will need to create this $2$D frame in SolidWorks and run a simulation to record the simulation results in the table

Exercise $2-$Listen to the recording$-$

For a $2$D loaded planar frame shown in Figure below, assume weldment segments are made of ASTM A$36$ ANSI inch square tube $4xx4"0\mathrm{.}25.omeg{a}_0=150\frac{lb}{in}$quad $F=10$kipquad $L=10ft$

Using SolidWorks Simulation, create a Simulation Study and complete the second column of the following Table. Create the file FirstLastL$0902$NR and upload the file in LH$.$