The $\_\_\_\_\_\_\_\_$ design phase is complete when the design is approximately $30$ percent complete.

Question $1$ options:

Schematic

Conceptual

Design development

Engineering

None of the above

Question $2($Mandatory$)(1$ point$)$

Saved

Unless otherwise specified, the specifications normally take precedence over:

Question $2$ options:

Codes.

Drawings.

Change orders.

Agreement

None of the above.

Question $3($Mandatory$)(1$ point$)$

Saved

The CM$\text{'}$s site office is usually responsible for which duties?

Question $3$ options:

Inspect all work

Coordinate and schedule work

Write daily reports

All of the above

Question $4($Mandatory$)(1$ point$)$

Saved

A project manager may direct a change in the Work when such change is authorized in writing by:

Question $4$ options:

The owner.

A code requirement.

A subcontractor.

The Builder.

A Supplier.

Question $5($Mandatory$)(1$ point$)$

Saved

A pre$-$construction meeting should be held:

Question $5$ options:

During the bid phase

After agreement but before Notice to Proceed

Prior to advertising for bids

After bid opening but after award of the contract

After Notice to Proceed

Question $6($Mandatory$)(1$ point$)$

Saved

The final decision regarding additions, deductions, and alternates in the Contract rests with:

Question $6$ options:

The Project Manager

The Contractor.

The Consultants

The Construction Manager

None of the above

Question $7($Mandatory$)(1$ point$)$

Saved

The Project Manager may reject materials or work if:

Question $7$ options:

If they do not like the containers they came in

It does not comply with the specifications

They do not approve of the manufacturer

The contractor did not get approval from the building inspector beforehand

Both B and D

None of the above

Question $8($Mandatory$)(1$ point$)$

Saved

Authorization to the contractor to perform work which involves a deviation from the requirements of the Contract Documents is called an:

Question $8$ options:

Addendum

Alternate

New contract

Change order

None of the above

All of the above

Question $9($Mandatory$)(1$ point$)$

Saved

The term "substantial completion," unless redefined in the Contract Documents, normally means that:

Question $9$ options:

The work is almost completed, but final completion will not occur until a later date

The contractor's obligations under the contract have been satisfied even though some minor items of pickup work remain

Liquidated damage provisions of the contract still apply until all pickup $($punch list$)$ work is completed

The architect or engineer may not process final payment until a certificate of "final completion" is executed.

Both A and B

Both C and D

Question $10($Mandatory$)(1$ point$)$

Saved

In which document is the contractor most likely to find the requirements for the type of material required to be used in the work?

Question $10$ options:

Plans

Specifications

Change Order

Bulletin

Question $11($Mandatory$)(1$ point$)$

Saved

In order to consider a $$2,651,000$ project substantially completed, the value of any un$-$finished or deficient items must not exceed:

Question $11$ options:

$$41,510\mathrm{.}00$

$$79,530\mathrm{.}00$

$ $1,000\mathrm{.}00$

$$26,510\mathrm{.}00$

Question $12($Mandatory$)(1$ point$)$

Saved

For a $$250,000$ project, it is deemed complete when the value of the deficiencies is less than

Question $12$ options:

$ $2,500\mathrm{.}00$

$ $7,500\mathrm{.}00$

$ $1,000\mathrm{.}00$

$ $500\mathrm{.}00$