Question: The frame ABC, supported by a clamp at A and a roller at C ; will be used to support a distributed load q acting

The frame ABC, supported by a clamp at A and a roller at C; will be used to support a distributed load q acting vertically downward, as shown in the figure. The cross-section of the beam is rectangular with the height =20cm and the width =10cm.E=200GPa and 2=300MPa.
a) Determine the reaction at C if q=20kNm and L=3m. Use Castigliano's second theorem.
b) Calculate the safety factor for this application according to the Tresca criterion. Neglect stresses caused by internal shear and normal forces.
The frame ABC, supported by a clamp at A and a

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

Q:

In a marginal tax rate system, as tax payers make increasing amounts of money, the tax rate they pay on every extra unit of income increases incrementally as their income passes certain cutoffs (...

Q:

Instructor: Ameh Fioklou, Ph.D., P.E. 1 of 7 CE 310 Elementary Structural Analysis Final Project Computer Applications Fall 2021 The objective of this project is to get you familiar with structural...

Q:

I want to know the answer for problem 1and 2 Discuss some of the alternatives and factors that Greg should consider when developing the expense allocation system. What are some of the costs and...

Q:

Beams are statically indeterminate generally because of their support systems. Beam ABC shown in Figure Q1 is supported by a fixed connection at C and two roller supports at B and A. The beam carries...

Q:

Problem # 3 : Rigid body equilibrium in 2 D ( 1 4 points ) Beam A B is supported at point A by a hinge and at point B by a roller. A distributed force acts on the beam as shown below and a force of 1...

Q:

DAN ANALYSIS WEEN MANALYSIS 5-15 Problem 5-15 ANALYSIS. 5-16 Problem 5-16 5-17 Problem 5-17 A rectangular steel bar supports the two overhanging loads shown in the figure. Using superposi- tion, find...

Q:

The steel beam is subjected to distributed load along span ABC as shown in Figure Q1(a). The beam is pin supported at A and roller supported at B and having cantilever beam along span BC. The...

Q:

Shear Force and Bending Moment Diagrams ( 2 0 points total, 3 parts ) The simply supported beam with span length of 2 1 - is loaded as shown below. A 4 . 4 k / ft uniformly distributed load acts...

Q:

The beam shown below is to be simply supported during storage. Sand has been evenly spread over a portion of the beam as a Uniformly Distributed Load (UDL) as shown below from A to C. Another two...

Q:

watch the three short clips below then answer the questions Copy and paste the three links below 1) Projectile Motion https://www.nsf.govews/mmg/mmg_disp.jsp?med_id=72205&from= 2) Newton's Second Law...

Q:

I need someone that is very good at Principles of accounting and finance to answer the attached questions. It is not a one-day job therefore if you do not have the time, please don't attempt it. The...

Q:

In a leveraged buyout of one company by another, the purchasing company usually obtains borrowed money and inserts as little of its own equity as possible into the purchase. Explain some...

Q:

"No organization can exist without conflict". Discuss.(10 mks) b) Discuss 6 approaches to solving conflicts in organizations.(10 mk) c) Describe6 causes of interpersonal conflicts(5 mks)

Q:

Which was not discussed as a contributor to the rates of completed suicides among males compared to females? Higher rate of suicide notes among males. The lendericy of mates to une more tethat...

Q:

Engaging your audience means that you- A bombard them with facts B speak slowly enough that people can digest your ideas C fail to hold their attention D use jargon related to the topic E do not...