The question requires you to produce a program to simulate the control of the level of water in a sump.

Please use tinkercad to show a circuit diagram using a Ardruino Uno R$3$ LEDs can be used to simulate the pumps and switches to simul IV$.$ Ilate the high and low sensors$.$ An alarm should be included. Please test the program to make sure it functions are per the specification When completed you submission should of the program source code $$ a copy of the source code file. FIGURE $1$ shows part of a control system used to maintain the water level in a sump between the levels high and low. Two transducers $($HIGH and LOW$)$ are used to monitor the level. The water is pumped out by two pumps, P$1$ and P$2.$ The water level in the does not reach low within about $30$ seconds, the second pump will come into action. If the level does reach low before $30$ second pumping should stop. $$ If the level does not reach low within about $30$ seconds of the second pump starting, an alarm is given. The alarm is sounded until the level reaches low. If the level does reach low before $30$ seconds the pumping should stop. grad The pumps will stop when low is detected. grad To give even loading of the pumps they are to be used alternately, e$.$g$.$ if on one pump cycle PI starts first and $P_2$ is the 'back up$\text{'}$ then on the next cycle $P_2$ will start first and $P_1$ is the "back up$"$ Please check your program functions as per the specification Must check that code works, code must alternate pumps on start cycle.

FIG. $1$