Question: Two steel plates are connected with ( 4 ) diameter bolts, and a 7 0 , 0 0 0 - pound tensile load is applied

Two steel plates are connected with

(4)

diameter bolts, and a

70, 000 -

pound tensile load is applied to the plate. What is the average shear stress in one bolt? Assume the shear force is evenly distributed between the bolts.

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

(a) The spliced connection shown in the figure below, is under the effect of an axial tension load (N* = 20 kN) originating from transient wind load actions only and acting along the grains of the...

(a) Two steel plates in axial tension are to be connected by bolts as shown in Fig. 7. Determine its tensile strength. Bolt dia = 25 mm, Hole dia = 28 mm, Plate thickness = 16 mm each, f = 440 MPa, f...

A 10 m long beam is uniformly distributed loaded (w= 7 kN/m )as shown in Figure 1 (a). The beam is made of two steel plates 209 x 20 mm and a universal beam section Section4 (See Table 1) that are...

Q3 [20] Two steel plates of identical thickness of 20 mm are fastened together to form a non-permanent tension joint. The bolt (nominal diameter 14 mm, coarse series, metric Grade 9.8) is chosen. A...

9 of 14 Questions Assignment Score: 71.6% Resources Ly Give Up? Hint Check Answer Press Esc to exit full screen 4 Question 45% 3 of co Attempts A person drops a cylindrical steel bar (Y = 1.700 x 10"...

I NEED A CLEAR EXPLANATION Background Your task is to design the nominated mechanical components associated with a 25 tonne overhead crane hoist drive. The layout of the hoist drive system is shown...

Problem 1 1. Axial load effects in Kips, where C-compression, T=tension) for various load types in members AB (D=10 (C). L=140 (T), W=160 (T)) and AC( D=20 (T), L=50 (C), W=135 (C) of a steel frame...

HOMEWORK 1-For a bolted assembly, two plates of cast iron are clamped together. Each cast iron assembly part has 0.75 inch thickness. The bolt is 43 in 16UNF221 in SAE grade 5 . (UNF-Fine Series)....

Problem 1 (2+8 marko Why is preloading important for a bolted connection? How should one control the applied presad? 11. A hydro-cylinder with an inner diameter of D-160 mm is shown in Figure 1. Oil...

A hollow cylindrical shaft with an outer diameter of 1 0 0 mm and an inner diameter of 8 0 mm is subjected to a bending moment of 1 2 0 0 Nm and a torque of 1 0 0 0 Nm . Determine the principal...

Ipswich Ltd is engaged primarily in agricultural pursuits as well as in forestry products, including the management of its own forest reserves. Unfortunately, in the current year an eruption of a...

A hydrogen atom in its ground state absorbs a photon of energy 12.1 eV. To what energy level is the atom excited?

1. A Boeing 757 crashed into the Pentagon on 9/11 only if two giant engines were found outside the building. It is not the case that two giant engines were found outside the building. Th erefore, a...

? Explain the correlation between employee professional development, organizational change, and organizational objectives.? Describe and Analyze the dynamics of organizational change and identify 1...