Unit $23|$ Tapers and Chamfers

UNLESS OTHERWISE SPECIFIFN ALL FILLETS ARE R$3$

$\backslash$table$[[3,136$ WAS $135,10/12/16,$D$.$G$.,\backslash$table$[[\backslash$table$[[$DATE$],[\frac{11}{02}\frac{?}{14}$

ASSIGNMENT D$-18$: OFFSET BRACKET

What is the height of the shaft carrier?

What is the angle of the offset arm to the body of the piece?

What is the center$-$to$-$center measurement of the length of the offset arm?

What radius forms the upper end of the offset arm?

What is the width of the bolt slot in the body of the bracket?

What is the length, center$-$to$-$center, of the bolt slot?

What revision was made at $(1)?$

What is the radius of the fillet between the pad and the body of the Offset Bracket?

What size chamfer is required on the $\frac{O}{10}$ hole?

What revision was made at $(2)?$

What size oil hole is required in the shaft carrier?

How far is the oil hole from the finished face on the shaft carrier?

What tolerance is applied to the $\frac{O}{10}$ hole?

What is the diameter of the shaft carrier body?

Determine distance $($A$).$

Determine distance $($B$).$

Determine distance $($C$).$

What surface finish is required on the shaft carrier and pad?

What does the line under the $136-$ mm dimension indicate?

Calculate the taper per inch and taper ratio for the following object.

a$.$ Taper Per Inch $=$

b$.$ Taper Ratio $=$

Unit $23|$ Tapers and Chamfers

UNLESS OTHERWISE SPECIFIFN ALL FILLETS ARE R$3$

$\backslash$table$[[3,136$ WAS $135,10/12/16,$D$.$G$.,\backslash$table$[[\backslash$table$[[$DATE$],[\frac{11}{02}\frac{?}{14}$