USING ASM

Use the MSP430G2553 Users Guide and Datasheet to write the code for Timer 0.

When writing the code it must be commented in detail. For example:

MOV.W #MC_1+TASSEL_1+TACLR, &TACTL ; Set timer to: Count up, Source ACLK, Clear Counter

Blink and LED every 500 mS using Timer A:

Configure the timer in Up Mode. Use ACLK as clock for the timer. Assume the ACLK has a 12KHz frequency.

The Timer should interrupt every 500 mS and an interrupt routine should toggle the pin P1.0 which is connected to the LED.