Using flip flops can you make the chart (present, next input, present output)

ENEE 2586 Lab 100-Elevator Control ENEE 2586 Lab Elevator Control The system has 2 inputs and 3 outputs Inputs 1 or Down It represents a button located inside the elevator or on the first floor, which may be used to take the elevator to the first floor, from any floor. 2 or Up It represents a button located inside the elevator or on the second floor, which may be used to take the elevator to the second floor, from any floor. Outputs 1st floor When this output is equal to logic 1, it indicates the elevator is at the 1stfloor. 2nd floor hen this output is equal to logic 1, it indicates the elevator is at the 2nd floor. Door When this output is equal to logic 1, it indicates the elevator door is open Details about the design: The system has four states, istfloor open door, ist floor closed door, 2nd floor open door, and 2nd floor closed door. The elevator should remain at rest until someone presses a button. The rest states are defined to be the states where the door is closed. If someone presses the 1 or Down button, the elevator should go to the 1stfloor, open the door (1st floor- 1, door 1) and remain in this state for a small amount of time, then close the door (1st floor 1, door 0). open the If someone presses the 2 or Up button, the elevator should go to the 2 door (2nd floor 1, door 1) and remain in this state for a small amount oftime, then close the door (2nd floor- 1, door- 0)