Using Fluidsim, please design a pneumatic circuit so that a large double-acting piston is used to punch a hole on a part. The piston won't be activated until the following conditions are met: a. Two hands are pushed together on two separate push buttons (two manual 3/2 valves and a two-pressure valve). b. A part is sensed by a roller-activated switch (a roller-activated 3/2 valve). c. When either hand does not touch the push button, the piston retracts. The forward speed must be at maximum (quick exhaust valve), but retract speed must be adjustable (one-way-flow-control valve). The minimum incoming air pressure must be at least 110 psi (pressure sequence valve). You will need a 5/2 direction control valve to deliver the pneumatic power to the piston. Hint: You need a 5/2 valve right before the air enters the cylinder