Using the procedure discussed in the Introduction, design an active band$-$pass filter with a

gain of $-10,$ a lower cut$-$off frequency of $150$Hz and an upper cutoff frequency of $5$kHz$.$ Be sure

to show all work and mention any relevant assumptions or design decisions.

Note: When choosing resistor values to set the gain for each stage, be certain to keep them very

large in the high k$\backslash$Omega range.

$*\backslash$omega $\_(1)=150$Hz

$*\backslash$omega $\_(2)=5$kHz

$*$ Gain $=-10$

please show your calculations as well as a schematic. i will upvote your answer if you do an excellent job, thanks! :)