Using two Arduinos, one HM$-10$ Bluetooth and three LEDs make a light controller system. This

system will use two different communication protocols: UART and I$2$C$.$ For the UART protocol

you are requested to use the HM$-10$ module with a terminal app to transmit an ascii character

to the transmitter $($TX$)$ Arduino at a baud rate of $9600$ bps$.$ After the ascii has been received in

the TX$,$ the receiver $($RX$)$ Arduino will receive that same ascii code via I$2$C$.$ TX will behave as the

master while RX will be the slave with the address $30.$ After K$...$

turn on one LED. You need to use three different ascii characters to turn on three dimerent LEDs.

Moreover, use other three ascii character to control the intensity brightness using PWM at three

duty cycles; $0\%,52\%$ and $96\%$