Question: Water ( = 62.4 lbm /ft3) flows through a horizontal bend and T section as shown. The mass flow rate entering at section a is

Water (ρ = 62.4 lbm /ft3) flows through a horizontal bend and T section as shown. The mass flow rate entering at section a is 12 lbm/s, and those exiting at sections b and c are 6 lbm/s each. The pressure at section a is 5 psig. The pressure at the two outlets is atmospheric. The cross-sectional areas of the pipes are the same: 5 in2. Find the x-component of force necessary to restrain the section.

Step by Step Solution

★★★★★

3.30 Rating (162 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Physics Questions!

A liquid of density 900 kg/m3 flows through a horizontal pipe that has a cross-sectional area of 1.90 x 10-2 m2 in region A and a cross-sectional area of 9.50 x 10-2 m2 in region B. The pressure...

To maximize the mass flow rate of air through a given nozzle, which properties should I try to change and in which direction, higher or lower?

To measure the mass flow rate of a fluid in a laminar flow through a circular pipe, a hot wire type velocity meter is placed in the center of the pipe. Assuming that the measuring station is far from...

Water ( = 1000 kg/m 3 ) flows through a horizontal bend and T section as shown. At section a the flow enters with a velocity of 5 m/s, and the pressure is 4.8 kPa gage. At both sections b and c the...

Water flows through a horizontal bend and discharges into the atmosphere as shown in Fig. P5.38. When the pressure gage reads 10 psi, the resultant $x$-direction anchoring force, $F_{A x}$, in...

Refrigerant-134a flows through a pipe of diameter 5 cm with a mass flow rate of 0.13 kg/s at 100 kPa and 10 m/s. Determine (a) The temperature (T). (b) Quality of the refrigerant in the pipe. Also...

5-43C Consider an adiabatic turbine operating steadily. Does the work output of the turbine have to be equal to the decrease in the energy of the steam flowing through it? 5-44C Consider an air...

A soft drink (mostly water) flows in a pipe at a beverage plant with a mass flow rate that would fill 220 0.355-L cans per minute. At point 2 in the pipe, the gauge pressure is 152 kPa and the...

An experiment is devised to measure liquid flow and convective heat transfer rates in micro-scale channels. The mass flow rate through a channel is determined by measuring the amount of liquid that...

A suspension of calcium carbonate particles in water flows through a pipe. Your assignment is to determine both the flow rate and the composition of this slurry. You proceed to collect the stream in...

Built - Tight is preparing its master budget. Budgeted sales and cash payments follow: July August September Budgeted sales $ 5 8 , 5 0 0 $ 7 4 , 5 0 0 $ 5 3 , 5 0 0 Budgeted cash payments for Direct...

cables 2,3, and 4 are all tensioned to 220 kN. (please draw a FBD!) a) if the moment at point F is zero what does the force in cable 1 have to be ensure equilibrium? b) What is the compression in the...

1. The distribution center for a chain of home improvement stores is focusing on paint. They handle a total of 25 base colors (5 each from 5 suppliers) so there are 25 SKU's of paint. (These are...

Although a disk stores data as a series of 1's and 0's, it is translated into ASCII and Hexadecimal and finally, a human-readable form depending on the application. What does the following Hex state...

12. The wheel shown is rotating at an angular velocity of 6 rad/s cw. You are required to determine the angular velocity of rod BC and CD at the instant rod CD is at 60 degrees, as shown in the...

Is Lift(MovadoConnect, battery), calculated from data set A, GREATER THAN, EQUAL TO, OR LESS THAN (Circle one) Lift(MovadoConnect, battery) using the combined data set A+B? Justify your response. You...

The Can Division of Sunland Company manufactures and sells recyclable containers externally for $0.80 per container. Its unit variable costs and unit fixed costs are $0.24 and $0.06, respectively....

The Place-Plus real estate development firm in Problem 24 is dissatisfied with the economists estimate of the probabilities of future interest rate movement, so it is considering having a financial...

Thin lenses Object O stands on the central axis of a thin symmetric lens. For this situation, each problem in Table 34-6 gives object distance p (centimeters), the type of lens (C stands for...

A 2140 kg railroad flatcar, which can move with negligible friction, is motionless next to a platform. A 242 kg sumo wrestler runs at 5.3 m/s along the platform (parallel to the track) and then jumps...

Energy can be removed from water as heat at and even below the normal freezing point (0.0oC at atmospheric pressure) without causing the water to freeze; the water is then said to be super cooled....

Find an article through ProQuest that discusses Donald Kirkpatrick's Four level Evaluation Model, devised in the 1970s and a standard tool in training circles, and evaluate the value and limitations...

How can the government make market participants 'internalize the externality' in the case of a negative externality? And the case of a positive externality?

Suppose a firm has the following labor productivity data: If the price of output is $10 and wage is $50 how many workers will this firm hire? What is 'rent seeking'?