we have to use Matlab for this

Now, we shall model our work in Task 1 in Simulink. So code will be represented in blocks. This will give us a high level control in the design of communication systems. High-level control abstracts the inner working of code and does not provide full insight into the internal mechanism of the building blocks of a system. In any case, Simulink is a great tool in simulating and emulating communication systems and other kinds of systems. Our purpose is to get more familiar with such a tool. In Simulink, click on the Library browser and select the following blocks: 1- Add 2- Product 3- Sine wave (2 blocks) 4 . Scope. Assign The sine waves the following parameters (10 points): Figure 2. Sine wave block 2 (higher frequency). Hence, one sine wave will have an amplitude of 1 and a frequency of 5Hz. And the other sine wave will have an amplitude of 1 and a frequency of 50Hz. Make sure to include the (2*pi) expression as the units of frequency in Simulink are in rad/sec. Provide screenshots for each of the following steps ( 10 points each): 1- Connect the blocks in the following manner: 2- Run the simulation and observe the scope display. 3- Change the amplitude of the 50Hz signal to 2 . And observe the outcome