Question: What is the mrr when a 1 . 5 in diameter hole, 2 in deep is drilled in 1 0 2 0 steel at a

What is the mrr when a 1.5in diameter hole, 2in deep is drilled in 1020 steel at a cutting speed of 200 fpm with a feed of .01 ipr

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Mechanical Engineering Questions!

Q:

A client requires a 1.5" diameter hole, 2" deep in 1020 steel. If a cutting speed of 200 SFPM with a feed of 0.01 ipr is used determine the following: MRR, cutting time, and required HP

Q:

Problem 4 - Forces in Deep Drawing (Found in Chapter 19) For the drawing operation of Problem 3 (Cup Drawing), the tensile strength of the sheet metal (low-carbon steel) = 300 MPa and yield strength...

Q:

A 250-mm-wide strip with a thickness of 20 mm is fed through a rolling mill with two powered rolls, each of radius = 200 mm. The work thickness is to be reduced to 17 mm in one pass at a roll speed...

Q:

5. A l 4 diameter hole is to be drilled through a 2 14" thick piece of steel plate. The twist drill is to be fed at 0.015 ipr. Maximum cutting speed of 80 fpm is recommended. Calculate: a. Cutting...

Q:

What is the metal-removal rate when a 1 1/2-inch-diameter hole, 2 in. deep, is drilled in 1020 steel at a cutting speed of 200 fpm with a feed of 0.010 ipr?

Q:

Problem 5 - Machining Time in Turning (Found in Chapter 21) A turning operation is performed on a cylindrical work part whose diameter = 150 mm and length = 500 mm. Cutting speed = 3.0 m/s, feed =...

Q:

A client requires a 1.5" diameter hole, 2" deep in 1020 steel. If a cutting speed of 200 SFPM with a feed of 0.01 ipr is used determine the following

Q:

Write a technical description for the Brita Stainless Steel Water Bottle with Filter, 20 Ounce Premium Double Insulated Water Bottle, BPA Free, Carbon. This description should include the following...

Q:

Course: Facilities Layout Planning Abstract This project illustrates a full design from the scratch for the lifting jack starting from the product, process and schedule design. Followed by Flow,...

Q:

Practice Problems 1 . Cast iron with Brinell hardness of 2 0 0 HB is turned with \ ( f = 0 . 4 0 \ mathrm { ~mm } \ ) with a depth of cut \ ( = 4 . 0 \ ) mm . The lathe motor is rated at 2 5 kW (...

Q:

List the main risks auditors will be concerned with in assessing risk in the production and payroll processes of a typical manufacturing business.

Q:

A boat leaves the entrance of a harbor and travels 57 miles on a bearing of N 11 E. How many miles north and how many miles east from the harbor has the boat traveled? A) 57 mi N, 57 mi E B) 56 mi N,...

Q:

Which of the following properly identifies the section of the carh flow teatement where each trarsaction or event would be reported. Select one: [ 7 a b . \ table [ [ Gearcaint , Inmerint:,Hinamelyt...

Q:

What input do both absolute valuation and relative valuation typically require? explain A. Historic revenue data. B. Long-term forecasts. C. Historic earnings data. D. Short-term forecasts.